TESTING FACILITIES

  • NDT Facilities
  • Mechanical testing Facilities
  • Heat Treatment
  • Pressure Testing

1. NDT facilities

RT: Radiographic Testing (Sub Vendor)

  • Radiography Capacity of up to 150mm thickness
  • X Ray Capacity- up to 36 mm
  • Gamma Ray Capacity: Up to 150 mm
  • Processing Dark Room – In House and Sub Vendor)

UT: Ultrasonic Testing (Sub Vendor)

  • UT facility for Scanning of Plates, Butt Welds & Fillet Welds

MPT: Magnetic Particle Testing Methods (Sub Vendor)

  • Dry Visible Power method
  • Wet Fluorescent Method
  • Testing Machine
  • Portable York, Probes & Permanent Magnets

LPT: Liquid Penetration Testing Methods (In House)

  • Visible Solvent Removal Methods
  • Fluorescent Solvent Removable Method

HELIUM LEAK TEST & VACUUM CREATING- In House

  • 1. Sniffer Method
  • 2. Vacuum Method

2. Mechanical and Chemical Testing (Sub Vendor – Met Heat Engg.)

  • Tensile
  • Bend
  • Micro Structure, IGC
  • Macro
  • Hardness
  • Spectro Analysis

3. Heat Treatment

Facilities for Heat Treatment

  • Closed Furnace : Heating By Electrical, Oil Fired & Gas Fired
  • Internal Fire Type : Heating by Diesel Fired
  • Local Area: Heating by Electric Coil

Type of Heat Treatment Carried out

  • Stress Relieving Heat Treatment
  • Normalizing
  • Post Weld Heat Treatment
  • Solution Annealing Heat Treatment
  • Tempering Heat Treatment

The above Heat treatment can be carried out for Individual Components & Complete equipments as per the requirement.

4. PRESSURE Testing

  • Hydraulic( 250 Kg / Cm2g)
  • Pneumatic( 70 Kg/ Cm2g)

5. Dimensional Check (In House)

  • Scales up to 12’’
  • Scales up to 36’’
  • Tape – 3/5/15/20 mtrs
  • Micrometers, Vernier Caliper
  • UT thickness Meter

6. Final Paint DFT check – 10 to 600 Microns - In House

7. Performance Test for Ejector (In House)

  • Water Jet Ejector : 200GPM water available at 11 Kg/cm2g
  • Air Jet Ejector : 12.5HP compressor with 125Psig pressure
  • Steam Jet Ejector : Up to 10 Kg/cm2 – 1 ton / hr